SAFETY DEVICES 6
AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A] 53
6.2 - Safety stickers
6.2.1 - Warnings for safety stickers
Some safety stickers have been applied on the vehicle and equipment in the positions shown below. Their purpose
is to provide a guide for your own and others safety. Before starting to work, check the content and location of the
stickers indicated on this manual. Review the safety stickers with all operators who will use the vehicle and
equipment.
ATTENTION
Make sure to have fully understood their correct location and their contents.
To ensure proper interpretation verify that they are in the correct position and that they are always kept clean.
DANGER
Clean them when they are covered by mud, concrete or debris.
It is absolutely forbidden to clean the stickers using solvents or gasoline; the labels may become discoloured.
See the summary table in the "Maintenance" chapter for the for safety stickers maintenance and control
deadlines.
Replace the safety stickers in case of deterioration, damage or loss, as these must always be read and
interpreted correctly.
WARNING
Do not under any circumstances remove the safety stickers.
NOTE
The purchase order of replacement safety stickers must be made in the same way in which any spare part is
ordered (be sure to communicate the model and serial number of the vehicle or equipment when placing the
order).
To Next Page
Loading...