4
SAFETY REGULATIONS
44 AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A]
• Always ensure good visibility in the work area,
including direct vision and visibility using wing
mirrors in order to check for the presence of
people, animals, obstacles, holes and changes in
slope etc.
• Decrease the working speed of the vehicle in case
of rain, fog, snow or in any case where visibility is
reduced.
• Always make sure there is good visibility (clean
windows, clean mirrors, clean lights that work
properly, etc.).
• Maintain control of the vehicle and its speed in all
circumstances. The speed of the loaded vehicle
must never exceed 10 Km/h.
• Do not drive in reverse for long distances.
• Brake gradually; avoid braking abruptly.
• Always maintain the safe distance from other
vehicles in order to have sufficient space to brake
in every condition.
• Always make sure that, during transport, the
drum is always rotating in the "Mixing" mode. This
reduces the loss of the load or part of it, and
avoids to cause danger of damage to things and
persons.
• Road use must occur with the shovel fully up and
locked to the appropriate safety chain.
• Do not raise or lower the drum or the loading
shovel when the machine is moving.
• Do not use the loading shovel to lift the rear
wheels of the machine, during the loading or
maintenance operations.
• With the engine running or drum moving, it is
obligatory make operations on the ground
operations while remaining at a safe distance of
safety from moving parts (loading shovel, drum,
etc ...).
DANGER
To check the consistency of the mix, pour
a small amount of it on the ground or in a
container. Do not try to check the mix
from inside the drum.
The operator must not climb to check the load or
to make washing operations.
The operator must not go inside the drum until it
is still mounted on the machine.
DANGER
It is absolutely forbidden to use hammers, chisels
or other tools to remove residual mixture from
the drum or from other parts of the machine.
4.13.1 - Drum loading
Figure: 170105-1
Proceed as follows to properly load the drum of the
machine:
• Put about half of the water required for the
mixture into the drum (see the "Water Pump"
chapter.
• Move the machine near the pile of aggregate to
be loaded.
• Turn the driver's seat, see the "Driver's seat
reversal" chapter.
• Set the drum rotation in the mixing direction at
maximum speed.
To Next Page
Loading...