7
COMPONENTS DESCRIPTION
66 AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A]
4. Turn the steering wheel adjustment lever up to
lock the steering wheel in the position in which it
is located. For correct locking, screw firmly.
NOTE
The steering wheel is properly adjusted when the
operator, with the back firmly against the
backrest of the seat, is able to grasp the furthest
side of the steering wheel while keeping the
elbow slightly bent.
7.1.8 - Steering selector
Figure: 150313-1
The steering selector (fig. 150313-1) is used to change
the wheels steering mode:
To select a steering mode, move the lever indicating
the corresponding symbol:
A - Four-steering wheels
This type of steering allows to carry out the steering
with all 4 wheels, so as to have the smallest turning
radius possible.
B - Front-steering wheels
This type of steering allows to carry out a steering with
only the 2 front wheels.
C - Transverse
This type of steering allows a transverse or crab
steering, so as to have a lateral displacement of the
vehicle.
DANGER
Make the steering selection only with the
vehicle stopped.
Before selecting a new type of steering, align the
wheels with stopped vehicle.
WARNING
When the transverse steering is selected, always
operate at low speed.
DANGER
It is absolutely forbidden to use the transverse
steering modes when the driver's seat is facing
the back of the machine.
ATTENTION
For road travel is mandatory to select the 4-wheel
steering mode and lock the selector with the
dedicated fastener "2".
Manual wheel alignment
ATTENTION
Perform the wheel alignment periodically (every
8-10 hours) depending on the continuous use of
the vehicle.
Figure: 150312-2
To Next Page
Loading...