COMPONENTS DESCRIPTION 7
AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A] 81
ATTENTION
With the hand throttle in operation, the vehicle
travel is disabled.
ATTENTION
When turning off the machine, the function must
be disabled and the engine must be brought to
the minimum speed.
WARNING
Do not use the electronic throttle in the cab
during the use of the basket and/or of the remote
control.
7.6 - Drum side rotation control
lever
WARNING
Make sure the vehicle is perfectly level
before rotating. The vehicle is unbalanced
on the unloading side if the drum is
turned sideways.
Only perform this operation on level ground so as
to prevent accidental overturning.
Move the lever “1” (fig. 161211-1)
as follows to move the drum
sideways:
• Push the lever towards
side "A" to rotate the
drum towards the left
side of the vehicle
• Push the lever towards
side "B" to rotate the
drum towards the right
side of the machine
A buzzer is heard during this
operation.
Release the lever for it to return to
the central idle position and the
movement will be stopped; the
drum will then stop in the
position reached.
161211-1
WARNING
Perform rotation with the engine at low rpm so as
to prevent anomalous unbalancing.
The drum must be aligned longitudinally to the
vehicle when driving on the road.
The drum must be aligned longitudinally to the
vehicle when performing the loading phase.
WARNING! If the door is
installed on the machine as an
option, do not rotate the drum
if it is fully open, there is the
danger of damaging the
machine.
161211-2
7.7 - Loading shovel control
lever
Figure: 161201-1
Move the relative lever ”1” (fig. 161201-1) as follows to
move the loading shovel:
• Push the lever towards side "A" side to lower the
loading shovel
• Pull the lever towards side "B" to lift the loading
shovel
Release the lever for it to return to the central idle
position and the movement will be stopped; the
loading shovel will then stop in the position reached.
To Next Page
Loading...