INTRODUCTION 2
AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A] 15
2.4.2 - Training
ATTENTION
The operator in charge of using the vehicle or
equipment must have attended a suitable
theoretical-practical course lasting as long as
indicated by legal prescriptions in the Country
where the vehicle or equipment is used.
Training must at least include the following subjects:
• Use and limits of the functioning and emergency
controls of the equipment and of the vehicle on
which the equipment is mounted
• Knowledge and awareness of the Use and
Maintenance Manual and of the control marks, of
the instructions and of the warnings applied on
the vehicle
• Knowledge and understanding of the Standard
on this equipment, including the educating
aimed at recognizing and avoiding potential
dangers at work
• Knowledge of the mechanical functioning of the
vehicle sufficient for recognizing a real or
potential failure
• Hints on constructive particulars of the vehicles
and on static and dynamic stability concepts
• Correct use of the vehicle procedures in safe
conditions with regard to the work place and the
load to be handled/lifted, capacity and guide
notions
• Knowledge and use of the PPE to be worn during
use of the vehicle and of the equipment
• Knowledge and execution of the routine
maintenance to be carried out
Training must be carried out under the supervision of
a qualified person in an open area and free from
obstacles. At the end of this practice, the trainee must
be able to safely use the equipment, and the vehicle
on which it is installed.
The operator must also be trained on the
responsibility and authority of not using the vehicle or
equipment in case of failure or presence of unsafe
conditions, and request further information from the
Manufacturer or authorized dealer.
2.4.3 - Qualification
The vehicle and equipment are intended for
professional use; their use must therefore be
entrusted to qualified figures, in particular:
• Being of adult age
• Be physically and psychically suitable to carry out
particularly difficult technical work
• Have been adequately trained on the use and
maintenance of the vehicle and equipment
• Have been judged suitable by the employer to
carry out the work entrusted to them
• Are able to understand and interpret the manual
and the safety requirements
• Know the emergency procedures and their
activation
• Have the ability of activating the specific type of
vehicle or equipment
• Are familiar with the specific standards of the
case
• Have understood the operational procedures
defined by the Manufacturer of the vehicle or
equipment
2.5 - Hazard Classification
Carefully read the safety regulations given and follow
all recommended precautions in order to avoid
potential risks and safeguard your health and safety.
The symbols listed below are inserted to highlight
situations which
DIECI S.R.L.
considers particularly
important.
If in doubt, contact your agent or dealer.
DANGER
It indicates an imminently hazardous situation
which, if not avoided, could result in death or
serious injury.
WARNING
It indicates a potentially hazardous situation
which, if not avoided, could result in death or
serious injury.
ATTENTION
It indicates a potentially hazardous situation
which, if not avoided, could result in minor or
moderate injury.
To Next Page
Loading...