Dieci L3500 - Braking Circuit Errors List; Deactivating the External Parking Brake Manually; Transmission; Movement Selection Lever

COMPONENTS DESCRIPTION 7
AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A] 77
7.3.2 - Braking circuit errors list
NOTE
In case the vehicle is in error, contact a
Dieci
service center to solve the problem, indicating
the error code reported.
For more information about the errors display,
refer to the "Instrument panel" chapter.
Icon Example Description
000000000 Parking brakes errors or
brakes failure
Code Description
100 Service brakes low oil level reporting
101 Parking brake system failure
102 Parking brake accumulator low pressure
7.3.3 - Deactivating the external
parking brake manually
150562-1 150562-2
The parking brake must be disengaged directly on the
axle to allow the vehicle to be towed.
• Place safety wedges under the wheels to prevent
the vehicle from moving suddenly
• Place a screwdriver on top of the crown (fig.
150562-1)
• With a rubber mallet give a sharp blow on the
handle of the screwdriver to push the crown
inward to release the lock.
• With the crown unlocked at the stroke end,
towards the outside of the vehicle (fig. 150562-2),
the parking brake is disengaged and it is possible
to tow the vehicle.
NOTE
The parking brake, even if disengaged, will return
automatically into operation when the engine is
started.
DANGER
Never use the vehicle with the negative parking
brake disengaged/disconnected.
7.4 - Transmission
7.4.1 - Movement selection lever
ATTENTION
In order to select a direction of movement, it is
necessary to move the movement selection lever
towards the steering wheel. This shifting protects
the lever from accidental operation.
With the movement selection lever in position
other than "N", it is not possible to start the
engine.
Figure: 150457-1
The movement selection lever, at the left of the
steering wheel (fig. 150457-1), allows to set the
direction of travel of the vehicle.
• Pull the lever towards the steering wheel and
push it forward ("F" direction) to proceed
forward.
• Pull the lever towards the steering wheel and pull
it back ("R" direction) to proceed in reverse. When
driving in reverse, an alarm sounds intermittently.
While holding the lever in an intermediate position
("N") the transmission is in neutral and the vehicle is
partially braked.
With the forward/reverse movement gear selection
lever in position other than "N",the engine will not
start.