EasyManua.ls Logo

Digi TransPort - Page 300

Digi TransPort
813 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configure Advanced interfaces settings
Digi TransPort User Guide 300
ppp n mask Valid IP address
Default
255.255.255.255
use mask a.b.c.d for this interface
ppp n DNSserver Valid IP address Primary DNS server
ppp n secDNS Valid IP address Secondary DNS server
ppp n DNSport Valid IP address
Default 53
DNS Port
ppp n IPmin Valid IP address
Default
10.10.10.10
Assign remote IP addresses from
a.b.c.d to a.b.c.d
ppp n IPrange 0-255
Default 5
Assign remote IP addresses from
a.b.c.d to a.b.c.d Note that these are
not directly equivalent. This address
is obtained by adding the range
value to the minimum.
ppp n transDNS Valid IP address Primary DNS server
ppp n sectransDNS Valid IP address Secondary DNS server
ppp n cingnb up to 25 digits Only allow numbers ending with n
ppp n msn up to 9 digits with ISDN MSN ending with n
ppp n sub up to 17 digits with ISDN sub-address ending with
n
cli
ppp n maxup 0-2147483648 Close the PPP connection after s
seconds
ppp n maxuptime 0-2147483647 if it has been up for m minutes in a
day
ppp n timeout Default 300s (5
minutes)
if it has been idle for h, m, s
ppp n timeout2 0-2147483648 Alternative idle timer for static
routes s seconds
ppp n rxtimeout 0-2147483648 if the link has not received any
packets for s seconds
ppp n maxneg 0-2147483648 if the negotiation is not complete in
s seconds
ppp n do_nat 0,1
0=Off
1=On
Enable NAT on this interface
Entity Instance Parameter Values Equivalent Web Parameter

Table of Contents

Related product manuals