Digisol DG-GS4528SE - Page 26

C ONTENTS
– 27 –
RSPAN Mirroring Commands 998
rspan source 1000
rspan destination 1001
rspan remote vlan 1002
no rspan session 1003
show rspan 1004
32 RATE LIMIT COMMANDS 1005
rate-limit 1005
33 AUTOMATIC TRAFFIC CONTROL COMMANDS 1007
Threshold Commands 1010
auto-traffic-control apply-timer 1010
auto-traffic-control release-timer 1010
auto-traffic-control 1011
auto-traffic-control action 1012
auto-traffic-control alarm-clear-threshold 1013
auto-traffic-control alarm-fire-threshold 1014
auto-traffic-control auto-control-release 1015
auto-traffic-control control-release 1015
SNMP Trap Commands 1016
snmp-server enable port-traps atc broadcast-alarm-clear 1016
snmp-server enable port-traps atc broadcast-alarm-fire 1016
snmp-server enable port-traps atc broadcast-control-apply 1017
snmp-server enable port-traps atc broadcast-control-release 1017
snmp-server enable port-traps atc multicast-alarm-clear 1018
snmp-server enable port-traps atc multicast-alarm-fire 1018
snmp-server enable port-traps atc multicast-control-apply 1019
snmp-server enable port-traps atc multicast-control-release 1019
ATC Display Commands 1020
show auto-traffic-control 1020
show auto-traffic-control interface 1020
34 LOOPBACK DETECTION COMMANDS 1023
loopback-detection 1024
loopback-detection mode 1024
loopback-detection recover-time 1025
loopback-detection transmit-interval 1026
loopback-detection release 1026