Digital Projection E-Vision Laser 13000 WU Series User Manual

Remote control Digital Projection Ltd. E-Vision Laser 13000 WU Series
Remote control
8
6
5
4
3
2
1
7
9
10
Pic Mute
OFF
ON
MENU
EXIT INFO
HDMI1
OK
OFF ON
ALT
LENS
FOCUS ZOOM
IN
OUT
IN
OUT
SHIFT
21 3
HDMI2 DVI
DISPLAYPORT
HD-T 3GSDI
VGA COMP1 COMP2
BRI
TEST
CON GAMMA
R G B ALL
3D EYE PIP SWAP
4 5 6
7 8 9 0
ALT
ADDR
OSD
OFF
ON
DEFAULT
FREEZE
RE-SYNC
A B C D
USER PRESET
Remote Control
1. Power ON / OFF
Turns power on and off.
2. Pic Mute OPEN / CLOSE
Shows and hides the projected image.
When OFF, the light source is completely switched off and the screen is black.
3. OSD ON / OFF
Enable and disable screen timeout messages and control whether to show the OSD during
projection.
4. MENU
Access the OSD. If the OSD is open, press this button to go back to the previous menu.
5. Navigation (arrows and OK)
Navigate through the menus with the arrows, confirm your choice with OK.
In lens adjustment modes, the arrows are used to move, zoom or focus the lens.
See 11 below. In lens adjustment modes, or when the OSD is not showing, the OK button
switches between modes: Shift Adjustment and Zoom / Focus Adjustment.
6. EXIT
Go up one level in the OSD. When the top level is reached, press to close the OSD.
7. FREEZE
Freeze the current frame.
8. DEFAULT
When editing a parameter, press this button to restore the default value.
9. INFO
Access information about the projector.
10. RE-SYNC
Re-synchronise with the current input signal
Installation & Quick Start Guide
Rev A June 2019
page 15
Notes

Digital Projection E-Vision Laser 13000 WU Series Specifications

General

Brand	Digital Projection
Model	E-Vision Laser 13000 WU Series
Category	Projector
Language	English