Digital Projection E-Vision Laser 13000 WU Series User Manual

Using the projector Digital Projection Ltd. E-Vision Laser 13000 WU Series
Memory
Memory
Recall Memory Default
Save Settings Preset A
Presets from one input
cannot be applied to
another input.
See on page1 for
information about the
parameters that can be
saved in a memory preset.
The current image settings can be saved as a preset, which you can recall later. The default settings can be
recalled at any time as well.
Up to four custom presets can be stored for each input.
The following settings are saved in a preset:
l From the Image menu — Dynamic Black, Gamma, Brightness, Contrast, Saturation, Hue, Sharpness
and Noise Reduction
l From the Color menu — Color Space, Color Mode, ColorMax, Color Temperature, Dynamic Black,
RGB Lift and RGB Gain
l From the Geometry menu — Aspect Ratio and Overscan.
To recall a saved preset:
l Select Recall Memory and press ENTER/OK, then select a preset from Preset A to Preset D. Select
Default to load factory default values.
To save a preset:
l Select Save Settings and press ENTER/OK, then choose from Preset A, Preset B, Preset C and
Preset D.
Operating Guide
Rev A June 2019
page 81
Notes

Digital Projection E-Vision Laser 13000 WU Series Specifications

General

Brand	Digital Projection
Model	E-Vision Laser 13000 WU Series
Category	Projector
Language	English