Digital Projection E-Vision Laser 13000 WU Series User Manual

Using the projector Digital Projection Ltd. E-Vision Laser 13000 WU Series
Some 3D settings explained
In order to achieve
maximum light output and
a smooth grayscale, whilst
eliminating ghosting, the
following procedure is
recommended:
1. Set Dark Time to a
value appropriate to the
glasses or ZScreen, say
1.3 ms or 1.95 ms.
2. Adjust Sync Offset time
to eliminate ghosting and
achieve a smooth
grayscale.
3. Repeat steps 1 and 2
until the best result is
obtained.
Dark time
Fully On
Fully Off
Left Right
Dark
Time
Dark
Time
Dark
Time
Banding can be caused if the image is displayed before each
eye of the 3D switching glasses or ZScreen is not fully open.
Dark Time allows you to minimize this effect.
Eye swap
LEFT 1 LEFT 2 LEFT 3RIGHT 1 RIGHT 2 RIGHT 3
Dominance Left
LEFT 1 LEFT 2 LEFT 3RIGHT 1 RIGHT 2 RIGHT 3
Dominance Right
The outgoing 3D frames are in pairs - the dominant frame
being presented first. You can determine which frame should
be the dominant one.
By convention the default setting is Left.
Operating Guide
Rev A June 2019
page 73
Notes

Digital Projection E-Vision Laser 13000 WU Series Specifications

General

Brand	Digital Projection
Model	E-Vision Laser 13000 WU Series
Category	Projector
Language	English