Digital Projection E-Vision Laser 13000 WU Series - Page 91

125 pages

To Next Page

To Previous Page

Served web pages Digital Projection Ltd. E-Vision Laser 13000 WU Series

Operating Guide

Rev A June 2019

page 91

Notes

Main Page

About this Document2
- Symbols Used in this Document2
- Product Revision2
- Legal Notice2
Laser Information3
Optical Radiation3
Light Hazard Warning4
- Light Hazard Distances4
Introduction5
Table of Contents6
Contents6
What's in the Box10
Connecting the Power Supply11
- Voltage Selection11
Projector Overview12
Control Panel13
- Projector Indicators14
Remote Control15
- Infrared Reception18
Positioning the Screen and Projector19
- Roll and Pitch20
Changing the Lens21
- Inserting a New Lens21
- Removing the Lens22
Switching the Projector off23
- Selecting an Input Signal23
- Selecting a Test Pattern23
- Adjusting the Lens24
  - Lens Menu24
  - Remote Control24
- Adjusting the Image24
Switching the Projector on23
Operating the Projector23
Signal Inputs26
- Digital Inputs and Outputs26
- Analog Inputs and Outputs26
- EDID on the Displayport, HDMI, and Hdbaset Inputs27
- Using Displayport/ HDMI/ Hdbaset Switchers with the Projector27
3D Connections28
- 3D Sources up to 60Hz Requiring Frame Doubling and Left/Right Interleaving29
- Frame Sequential 3D Sources up to 120Hz29
- Dual Pipe 3D29
- 3D Sync30
Control Connections31
- LAN Connection Examples32
- RS232 Connection Example33
- Using the Menus36
- Opening the Menu36
- Opening a Submenu36
- Exiting Menus and Closing the OSD37
- Inside a Menu37
- Accessing Sub Menus38
- Executing Commands38
- Editing Projector Settings39
  - Using a Slider to Set a Value39
  - Editing Numeric Values40
Using the Projector41
- Main Menu41
- Lens Menu42
  - Lens Control42
  - Lens Memory43
- Image Menu44
  - Position and Phase45
  - Noise Reduction46
- Color Menu47
  - Color Space47
  - Color Mode48
- Geometry Menu52
  - Aspect Ratio52
    - Theaterscope Setting53
  - Digital Zoom54
- Overscan55
- Blanking56
- Keystone57
  - Keystone Example58
  - Keystone Settings59
- Corners60
  - Top Right Corner Example61
- Rotation62
  - Rotation Example63
- Pincushion / Barrel64
  - Pincushion/ Barrel Example64
- Arc65
- Custom Warp66
Edge Blend Menu67
- Blend Start68
- Blend Width69
- Black Level Uplift70
3D Menu71
- 3D Types72
- Some 3D Settings Explained73
Laser Menu75
Setup Menu76
- Colormax78
- Network Menu82
- PIP Menu83
- Information Menu84
Served Web Pages87
Choosing a Lens94
- Basic Calculation95
  - Basic Calculation Example96
- Full Lens Calculation97
Screen Requirements100
- Fitting the Image to the Display100
- Diagonal Screen Sizes101
- Positioning the Image102
Aspect Ratios Explained104
- Aspect Ratios Examples104
- Aspect Ratio Example: Theatrescope106
Appendix A: Supported Signal Input Modes107
- Formats107
- Formats109
- SDI Formats111
Appendix B: Wiring Details112
- Signal Inputs and Outputs112
- Control Connections115
  - Lan115
- Rs232115
  - IR Input115
Appendix C: Glossary of Terms116

Digital Projection E-Vision Laser 13000 WU Series - Page 91

Table of Contents

Related product manuals