DISPLAY MESSAGES AND FAULT FINDING
4--10 27080 Issue 1 August 98
Ink temperature low
Ink temperature is outside control system limits.
Ensure printer environment is within specification.
Invalid or missing Font file
Font file missing or corrupted.
Replace the font file.
Invalid or missing Raster file
Raster file is either missing or corrupted.
Replace the raster file.
Long print, check print quality
Long print generated.
Inspect print quality.
New Store file created
This message is displayed for information only. It indicates that
a new file store (for the display of messages, logos etc.) has been
created. Thismayhappenif theprinterhasbeenreconfigured(to
use a different ink type, nozzle size or print format).
No ink
Ink level is below minimum.
Fit a new ink cartridge.
No make--up
Make--up level is below minimum.
Fit a new make--up cartridge.
PEC config. item defaulted
Configuration data not available (during initialisation).
Initialisation will be continued using default values.
Print Engine Standby timed--out
Printer has remained in standby state for longer than the pre--set
time (and sequenced full off).
Start up printer if required.
To Next Page
Loading...
Need help?
General
