Monitoring
176 Instructions for Use Apollo SW 4.5n
Part Number: 9053586, 3rd edition
To select the area:
1. Turn the rotary knob = the dashed frame moves.
To enlarge the selected area to the full width of the
display:
1. Press the rotary knob.
A new dashed frame appears after a corresponding
period of operation which can also be enlarged.
To return to the trend overview:
1. Press the >Trend Full View< button
(5 in Figure 103) and the complete trend is
displayed again.
This button is ineffective if there is insufficient trend
data available (e.g. less than 30 minutes of
operation).
Deleting the trend memory
Figure 104. Delete Trend Key on Standby ScreenDeleting trend memory is only possible in Standby.
Trend memory, mini trends (optional) and Datalog
are deleted simultaneously!
1. Press the standby key > < located on the side
of the monitor screen, and press the rotary knob
to confirm.
2. Press the >Delete Trend< button on the standby
screen (1 in Figure 104).
A confirmation screen appears with new buttons and
the prompt: “Press >Delete< to delete trend curves
and Datalog entries.” (refer to Figure 105).
3. Press the >Delete< button to delete all trend and
Datalog data (1 in Figure 105).
Figure 105. Confirm Cancel Screen in Standbyor
Press the >Cancel Delete< button to cancel the
deletion (2 in Figure 105).
To Next Page
Loading...
Need help?
General
