Troubleshooting
110
Message Cause and Solution Page
Cause :
Master roll cover is open.
Solution :
Close the cover.
101
Cause :
The master roll is not set correctly.
Solution :
Reset it correctly.
122
Cause :
The document is jammed on the ADF.
Solution :
Remove the jammed document.
-
Cause : The printer is not ready.
Solution : Please wait with the power
“
ON
”
.
¡
If the message remains after a few minutes
a
Turn the power
“
OFF
”
and
“
ON
”
again.
¡
If the message still remains after a few minutes
a
Turn the power “OFF” and contact your service person.
9
Cause : The key card is not inserted.
Solution : Insert the key card into the key card counter.
For details, see the Key Card Counter Instruction Manual.
10
MASTER ROLL COVER OPEN
SET MASTER ROLL PROPERLY
ADF PAPER JAM
PLEASE WAIT
RE-INSERT CARD
Cause :
There is an error during master setting.
Solution : Open the top cover and remove the master that
is left in the plate feeder.
121
MASTER SETTING ERROR
Cause :
Two or more sheets of paper are fed.
Solution : After removing the double-fed paper, check the
“paper feed pressure” and “separation pressure”.
1
This is detected when “9.
DOUBLE FEED DETECTION
”
in the special function is set to
“ON”.
114
82
DOUBLE FEEDING ERROR
To Next Page
Loading...
General