44
Multiple Printing on One Page
dd
[ 2-in-1 Layout ]
2Two-in-one (2-in-1) mode allows you to print two small documents on one page and also
easily print for creating booklets that will be saddle stitched.
When you use 2-in-1 mode, the layout is as follows:
2-in-1 Layout [Available only with ADF installed ]
"Select “2-in-1 Layout” before starting platemaking.
"You cannot use 2-in-1 mode unless the optional ADF is installed.
"Always load the documents in the ADF.
"If you are printing the documents at 100%, select a printing paper that is the size of the two
documents.
"When you enlarge or reduce two documents size by side, select a zoom ratio so that the
documents fit exactly on one page.
"Note the following when using 2-in-1 layout mode:
"
You must load the document in the ADF in portrait orientation.
"
You must select a paper size and zoom ratio that will accommodate two documents.
"Correct layout may not be obtainable with other than standard size papers.
IMPORTANT
:
440256e
To Next Page
Loading...
General