19
2.
Printing
s
Loading Document in ADF [Available only when ADF is installed]
1
Align the “document guides” with the marks for
the size of document to be loaded in the ADF.
2
Place the “document face up” in the document
tray.
Platemaking starts with the top document in
the tray.
Load documents that consist of a series of sheets to be printed in the ADF.
When one or more documents are loaded in the ADF, platemaking and printing are
automatically repeated until the document tray is empty.
"
ADF mode is automatically selected when a document is loaded in the ADF.
The ADF then takes priority over the document glass plate in the platemaking process.
The document can be loaded in the “portrait” or “landscape” position.
"
A4, B5, and A5-size documents can be loaded in the
“
portrait
”
or
“
landscape
”
position.
"
Use the landscape position when enlarging or reducing from standard-size documents
to standard-size paper, such as A4 to A3.
"
A3 and B4 documents can only be loaded in the landscape position.
IMPORTANT
:
IMPORTANT
:
s
How to load document (ADF)
When printing sheet-type documents in succession
"
Do not attempt to remove or add to the
documents in the document tray while
platemaking and printing are in progress.
IMPORTANT
:
440ADF003q
440ADF002
Document Guides
440ADF003
Document size
Printing
face up
2Portrait (Vertical) Placement 2Landscape (Lateral) Placement
Document
Document Tray
(Basic)
Loading Document
To Next Page
Loading...
General