118
When “PLATE EJECTION ERROR” is Displayed
s
When “PLATE EJECTION ERROR” is Displayed
When and old master remains on the drum,
“
PLATE EJECTION ERROR
”
is displayed on the LCD
panel. Remove it by following the procedure below.
s
Removing the master adhering to the drum
"
Do not press the surface of the drum unit with your fingers or scratch it.
Doing so will not only dirty your fingers or clothing but will also indent the
drum unit surface, preventing normal printing.
"
Before placing the drum unit, check the location for other objects so that it is
placed on a level surface.
"
Scratches or dents on the drum unit surface prevents normal printing.
WARNING
1
Open the “front cover”.
2
Press and hold the “JOG switch” until the
drum comes to a stop with a beep.
JOG switch
440015
3
Pull up the “drum securing lever” towards
you, and hold and pull out the “drum handle”
towards you until it comes to a stop.
Drum securing lever
440016
"
Do not touch the drum or rollers when you
operate the JOG switch.
"
Do not put your hands or fingers inside
the machine while it is operating. Your
hands may be pulled in or nipped.
WARNING
Drum handle
Front cover
440210a
Lights up
To Next Page
Loading...
General