15
Basic Printmaking
2.
Printing
6
Press (PLATE MAKING) key.
When the plate has been made, one test print
is automatically made.
"
The test print is for verification purposes
only and may be fainter than the final print.
IMPORTANT
:
8
Use the key pad to specify the “number of
prints” to make.
"
You can specify up to 9999 prints.
NOTE
:
¡
If you make a mistake entering the
number of prints
q
Press (CLEAR) key then enter the correct
number.
"
You can enter the number of desired prints before
pressing (PLATEMAKING) key to immediately
print the required number of copies.
NOTE
:
Key pad
9
Press (PRINT) key.
The “feed tray” rises so that the top of the
paper stack is the height of the feed roller.
The print run starts and the count displayed
on the LCD panel is decremented by one for
each print made.
The printed pages are output to the “print tray”.
¡
To stop a print run
q
Press (STOP) key. To restart the print
run, press (PRINT) key again.
¡¡¡
Repeat steps
3
to
9
to print multiple documents.
¡¡¡
¡
Example: When “1” , “0” and “0” are pressed
on the keypad.
5
Set the “paper stacker guides”, “stacker
stopper” to the paper width.
a
See page 24
NOTE
:
7
Check the “printing finish”.
Check if the print is made in the optimal position.
(Basic)
To Next Page
Loading...
General