Batch Printing
dd
Sequential Batch Printing
55
Printing
3.
9
Press (PLATEMAKING) key.
Platemaking starts.
When the print run for the first document has
completed, load the next document on the
document glass plate.
12
Steps
9
and
10
are repeated until the entered
sets are completed.
"
Using the optional tape cluster and optional
ADF you can successively perform the
platemaking and collating of prints of
multiple documents.
NOTE
:
¡
If you are using the ADF
If you are using the ADF, load the document
for the first-entered number of prints and
sets at the bottom and the document for
the last-entered number of prints and sets
uppermost.
10
"
Platemaking and printing starts from the
last-entered print and set quantities.
IMPORTANT
:
11
Press (PLATEMAKING) key. Platemaking
and printing of the next document starts.
4
Use the key pad to enter the number of sets.
Example: 3 sets
5
Press key.
The LCD panel changes to indicate the number
of prints, and the first entered number of
prints is displayed.
6
Repeat steps 2 to 5.
7
Check the settings for any errors using the
“Current Setting Function".
“Current Setting Function”
a
see p.94
8
Proceed with steps
2
to
5
of the sequence
described in “ Basic Printmaking”.
“ Basic Printmaking”
a
see p.14
(Advanced)
To Next Page
Loading...