DURKOPP ADLER 1767 - Page 96

Programming
94 Service Instructions 1767 - 00.0 - 12/2016
B- • Decreases parameter
• Changes to next lower
category
• Selects subprogram
C- • Decreases parameter
• Selects subprogram
D- • Decreases parameter
• Selects subprogram
Reset • Resets the (piece)
counter
④
Seam program button group
Seam program I • Activates seam
program I
 Instructions
for use
DAC basic/
classic
Seam program II • Activates seam
program II
 Instructions
for use
DAC basic/
classic
Seam program III • Sets seam program III  Instructions
for use
DAC basic/
classic
No. Button Function Reference