DURKOPP ADLER 513 - Page 116

Troubleshooting
114 Operating Instructions 513/533 - 01.0 - 09/2023
M-301 Memory
abnormal
Control panel memory data
abnormal.
• Internal error: The user needs
to update the software of the
control panel.
M-302 Machine type
parameter error
The machine type data read by
the control panel is outside of
the set range.
• Press the RESET button
to call up parameter 241
automatically and select and
save the corrected machine
type.
M-303 UK parameter
abnormal
Abnormal range of the
parameter that was read from
the EEPROM by the control
panel.
• Press the RESET button to
call up the system menu and
restore the default setting.
M-304 Main PCB
parameter
abnormal
Abnormal range of parameters
received from the control by the
control panel.
• Press the RESET button to
call up the system menu and
restore the default setting.
M-305 Normal seam
pattern
parameter
abnormal
During the use of seam pattern
parameters, the control panel
detects an abnormal parameter
range.
• Press the RESET button to
call up the system menu and
restore the default setting.
M-306 Error
Seam pattern
number
The selected seam pattern is
not stored in ROM or has been
disabled. The seam pattern is
"0"
• Press the RESET button to
confirm the seam pattern
number.
M-307 Seam pattern
data abnormal
While the sewing data of the
seam pattern is read by the
control panel, the system
detects an abnormal data
format.
• Select different seam
patterns.
M-308 Sewing data too
great
The volume of the seam pattern
data is found to be too great
during the calculation.
• Select different seam patterns
for sewing.
Error Description Possible cause Troubleshooting