Programming
Operating Instructions 513/533 - 01.0 - 09/2023 57
U033 Set the number of stitches released by
the thread-pulling knife
1 to 7 stitches Stitches 2
U034 No delay at thread-pulling knife -10 to 0 - -5
U035 Thread-pulling knife
(if yes, parameters U002-U007 apply;
if no, parameters U010-U016 apply)
0=yes
1=no
-1
U036 Select the feed time.
If the stitches are not tightened prop-
erly, change the value towards "-".
-8 to 16 - -8
U037 Sewing foot status at the end of
sewing
0 = return to sewing
start, then lift
1 = return to sewing start
and lift at the same time
2 = lift sewing foot
manually by pressing
the pedal
-1
U038 If the sewing foot fails to lift, you can
only start sewing by using the pedal
0 = normal
1 = do not lift sewing foot
-0
U039 Look for initial stitch position at seam
end
0 = do not look for origin
1 = look for origin
-0
U040 Look for origin during cyclical sewing 0 = do not look for origin
1 = look for origin at the
end of each seam pattern
2 = entire cycle ends
-0
U041 Look for origin while sewing the seam
pattern
0 = do not look for origin
1 = look for origin
-0
U042 Stop position of needle bar 0 = upper position
1 = highest position
-0
No. Function Value range Unit Default
To Next Page
Loading...
