Winder
66 Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Setting the winder spacing
Fig. 53: Setting the winder (2)
Fig. 54: Setting the winder (3)
To set the winder spacing:
7. Turn the winder spindle (6) such that the thread-pulling knife (5) is at
the top right and is facing the right-hand screw hole (7).
8. Loosen the threaded pin in the block (8).
9. Set the winder lever (3) such that the upper arm is above the marking
for the XXL hook (11).
The distance between the winder lever and the outer thread on the
bobbin is 2 – 3 mm.
10. Set the block (8) such that it is resting against the locking disk (9).
11. Set the block (8) such that its distance to the winder wheel (10) is
0.5 mm.
12. Tighten the threaded pin in the block (8).
(3) - Winder lever
(5) - Thread-pulling knife
(6) - Winder spindle
(7) - Right-hand screw hole
(8) - Block
(9) - Locking disk
(10) - Winder wheel
(11) - Marking for XXL hook
To Next Page
Loading...
