Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 129
Height of sewing foot lift at
Sewing stop
Value range
00 – 20 [mm]
(depending on subclass)
Backwards
When the parameter is activated, the
section is sewn backwards.
Value range
On/Off
Seam Center Guide
(only on 2-needle machines, optional
additional equipment)
Value range
On/Off
Puller
(optional additional equipment)
The puller supports the transport of the
sewing material. The feed of the two roll-
ers is calculated automatically based on
the stitch length of the machine.
An adjustment may be necessary
depending on the application.
The rollers of the puller can be adjusted
separately. The input is in percent: a pos-
itive value increases the roller feed while
a negative value reduces the feed.
On/Off
Correction top roller
Value range
-100 – 100 [%]
Correction bottom roller
Value range
-100 – 100 [%]
Gap
(optional additional equipment)
The edge guide helps to precisely posi-
tion the sewing material. The value set
indicates the distance between the nee-
dle and edge guide/material edge.
Value range
01.0 - 45.0 [mm]
Light barrier
(optional additional equipment)
The light barrier detects the beginning
and the end of the material. After a signal
was detected, sewing can continue
automatically with the specifically set
parameters.
Value range
On/Off
(see p. 130)
Output
Output 01-16 (see p. 131)
Icon Parameter Setting
To Next Page
Loading...
