DURKOPP ADLER M-Type Delta D867 - Page 89

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 87
Software / Stitch Counter
In Software mode, the bobbin is
monitored by the software based on
the number of stitches sewn.
Counter Type
4 different counters can be applied.
The following 3 subitems can be set
for each of the counters.
Value range
A/B/C/D
Counter value
Bobbin supply capacity in stitches.
This is a very variable value, which
depends on the size of the bobbin
and the thickness of the thread.
Value range
00000 - 99999
Sewing stop
Sewing stops and a notice is shown
on the display when the bobbin is
detected to be nearly empty. If the
parameter is not activated, only the
LEDs on the machine arm give a
warning if the bobbin is empty.
Value range
On/Off
Sewing foot lower position Value range
On/Off
Reset necessary
It is only possible to resume sewing
after changing the bobbin and
confirming the message on the
control panel.
Value range
On/Off
Menu item Setting option 1 Setting option 2