Dynapac D.ONE - Page 185

Fault
description
Cause Remedy
Current at output Display value = output current in Amperè
5062 Output relay K 11, potential
changeover
0000 = Output not triggered
0001 = Output triggered
Logic level of control 0000 = Output not triggered
0001 = Output triggered
5070 Output relay K 39, starter Display value = output voltage in Volt
Voltage at output Display value = output voltage in Volt
5071 Output relay K 39, starter Display value = output current in Amperè
Current at output Display value = output current in Amperè
5072 Output relay K 39, starter 0000 = Output not triggered
0001 = Output triggered
Logic level of control 0000 = Output not triggered
0001 = Output triggered
5080 Output horn, H 07 Display value = output voltage in Volt
Voltage at output Display value = output voltage in Volt
5081 Output horn, H 07 Display value = output current in Amperè
Current at output Display value = output current in Amperè
5082 Output horn, H 07 0000 = Output not triggered
0001 = Output triggered
Logic level of control 0000 = Output not triggered
0001 = Output triggered
5085 Output 2 horn, H 07 Display value = output voltage in Volt
Voltage at output Display value = output voltage in Volt
5086 Output 2 horn, H 07 Display value = output current in Amperè
Current at output Display value = output current in Amperè
5087 Output 2 horn, H 07 0000 = Output not triggered
0001 = Output triggered
Logic level of control 0000 = Output not triggered
0001 = Output triggered
5100 Coolant temperature sensor, B 53 0000 = Temperature too high, excessive temperature
0001 = Temperature OK
Appendix – Input codes for BLM control
D.ONE
185