D 4.6 19
D_4.6_01_GB.fm 19-38
When work is finished
- Run the paver finisher empty and stop
it.
- Lift the screed. Set the switch (1) to
mid-position, switch (2) to the upper
position and switch (3) to lifting.
- Retract the screed parts to the basic
screed width and lift the auger. Where
applicable, completely extend the lev-
elling cylinders.
- Insert the mechanic screed transport
safeguard (74) on both screed lifting
cylinders.
- While operating the tampers at a low
speed, let any material residues drop
out.
- Set the drive lever (5) to the center po-
sition and the speed adjuster (6) to
minimum
- Switch off the ignition.
- Switch off screed heater (system).
- When screed is operated with the op-
tional gas heating system, close the
main shut-off valves and the valves of
the bottles.
- Remove the levelling units and stow
them away in the boxes, close all flaps
- Remove all parts that extend beyond
the paver finisher contour or secure
them if the paver finisher is to be trans-
ported over public roads on a low-bed
trailer.
Element1_konv_Kette_635.bmp
2
3
1
F0083_A1.Tif
74
Element2_konv_Kette_635.bmp
6
5
To Next Page
Loading...
Need help?
General
