D 4.6 4
D_4.6_01_GB.fm 4-38
1.1 Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and be-
ginning operation, the following steps
must be performed:
- Daily maintenance of the paver finish-
er (see chapter F)
m
Check the operating hour counter to de-
termine whether or not additional main-
tenance work (such as monthly or yearly
maintenance) must be performed.
- Check the safety devices and protec-
tive devices.
„Normal” starting
Set the drive lever (1) to the center posi-
tion and the speed adjuster (2) to mini-
mum.
- Insert the ignition key (3) in position
„0”. The lights should be switched off
during starting to reduce the current
drain on the battery.
A
Starting is not possible if the drive lever
is not in the central position or if the mo-
tor stop control light (4) is On (the emer-
gency stop button (5) or the one on the
remote control (o) is depressed, the au-
ger and the conveyor switches are
turned).
- Press the starter button (7) to start the engine. Do not let the starter run permanent-
ly for more than 20 seconds; allow for a break of 1 minute after every attempt
Element2_konv_Kette_635.bmp/Element3a_konv_Kette_635.bmp
2
4
6
3
1
7
5
To Next Page
Loading...
Need help?
General
