E 01 1
E_01_GB.fm. 1-18
E 01 Set-up and modification
1 Special notes on safety
f
Danger to personnel by inadvertent starting of the engine, the traction drive, the con-
veyor, the auger, the screed or the lifting units. Unless specified otherwise, work may
only be performed when the engine is at a standstill!
- To protect the paver finisher against inadvertent starting:
Set the drive lever to the center position and set the preselector to zero; if applica-
ble, remove the drive traction fuse from the operating panel; pull out the ignition key
and the battery main switch.
- Secure lifted machine parts (e.g. screed or hopper) against lowering by means of
mechanical supports.
- Replace parts or have them replaced as stipulated.
f
When connecting or disconnecting hydraulic hoses and when working on the hydrau-
lic system, hot hydraulic fluid can spurt out at a high pressure.
Switch off the engine and de-pressurize the hydraulic system! Protect your eyes!
- Mount all protective devices before re-commissioning the paver finisher.
- The walking platform must always reach over the entire width of the screed. The
hinged walkway (option for all variable screeds) may only be swung up under the
following circumstances:
- When paving next to a wall or a similar obstacle.
- During transportation on a low-bed trailer.
To Next Page
Loading...
Need help?
General
