C 1.1 5
C_1.1_01_GB.fm 5-14
2.3 Secure the paver finisher in its position to the low-bed trailer:
- Use only proper and permitted load fastening devices.
- Use the four securing points provided (1, 2).
A
Depending on the equipment of the machine there can be further support points (3)
on the auger frame (3).
- Wait until the exhaust extension pipe has cooled down; then remove it and store it.
2.4 After transportation
- Remove the attachment devices.
- Swing up the protective roof: take out the bolts, push the protective roof forward to
raise it and insert the bolts to lock it again.
- Mount the protective tarpaulin if it has been removed.
- Lift the screed to the transportation position and lock it.
- Start the engine and drive from the trailer at a low engine/traction speed.
- Park the paver finisher in a secure spot, lower the screed and switch off the engine.
- Remove the key and/or cover the operating panel with the protective hood and se-
cure it.
To Next Page
Loading...
Need help?
General
