F 10.0 5
F_10.0_01_GB.fm. 5-6
5 Conservation of paver finisher
5.1 Downtime up to 6 months
- Stop the machine in a place protected from intensive sunshine, wind, moisture and
frost.
- Lubricate all the lubrication points with grease as specified, use the optional central
lubrication unit as appropriate.
- Change the oil in the Diesel engine
- Tightly seal the muffler of the exhaust pipe.
- Remove the batteries, charge and store them at room temperature in well ventilat-
ed premises.
m
Recharge the dismounted batteries every 2nd month.
- Protect all shiny metal surfaces, e.g. piston rods of the hydraulic cylinder against
corrosion using an appropriate agent.
- If the machine cannot be halted in a closed hall or under a shed, it must be covered
with an appropriate canvas. In each case all the air inlets and outlets shall be tightly
sealed using plastic film and adhesive tape.
5.2 Downtime between 6 months and 1 year.
- Perform all operations described for „Downtime up to 6 months“.
- After draining the engine oil, fill the engine with conservation oil permitted by the
manufacturer of the engine.
5.3 Re-commissioning:
- Perform the operations opposite to what were described in the section „Downtime“.
To Next Page
Loading...
Need help?
General
