E 01 14
E_01_GB.fm. 14-18
- Lock the material shaft (5) with bolts (6), washers (7) and nuts (8) to the basic de-
vice.
- The material shaft can be adjusted in order to match the existing shaft.
- Loosen the nuts (9) for this and turn the sleeve (10) of bolt (6).
- Mount the extension of the auger shaft (11) on the auger shaft of the basic device.
- Fasten the auger segments (12) using bolts (13), washers (14) and nuts (15) for the
extension of the auger and simultaneously bolt the auger shafts firmly together.
A
If the application conditions on the job-site allow or demand auger extension, by all
means dismount the external bearing of the auger (16), if the auger extension is long-
er than 600 mm.
When extending the auger on the basic device with external auger bearing, the short-
er auger segment shall be mounted on the bearing. In the opposite case, both the au-
ger segment and the bearing may get damaged, when paving with 30 mm aggregate.
To Next Page
Loading...
Need help?
General
