Dynapac F 121 C User Manual

F 5.1 6
F_5.1_01_GB.fm 6-12
Changing the oil filter:
A
As part of the oil change mount the new filter after the used oil was drained.
- Untighten the filter (D) and clean its resting surface.
- Apply thin coat of oil to the seal of the new filter and fill the filter with oil before
mounting.
- Tighten the filter by hand.
A
After mounting the oil filter check the oil pressure gauge and the proper tightness dur-
ing the trial operation. Check the oil level once again.

Dynapac F 121 C Specifications

General

Brand	Dynapac
Model	F 121 C
Category	Construction Equipment
Language	English