Dynapac F6C - Page 57

D 17
D F6C.GB 17-50 0504
Item Designation Brief description
33
Temperature indi-
cator for hydraulic
oil
Normal display up to 85 °C = 185 °F.
$
The relevant LED (red) flashes at higher temperatures
- stop the paver finisher (drive lever in the centre posi-
tion), let the engine cool down while idling. Determine
the cause and correct it if necessary.
34 Engine stop
Lights up when the engine cannot be started (e.g. because
the emergency stop button has been pressed).

In this case, see the section „Malfunctions“.
35
Fault indication
from travel drive
A defect in the automatic drive control (signal from RC6-9) is
present.

Precise diagnosis involves reading out the fault at BB3.
When serious defects occur, e.g. failure of the steering
potentiometer, work must be temporarily stopped.
36 not in use
37 not in use
38
Traction indicator
(green)
Lights up when the drive lever in the drive position.
- The engine cannot be started.
39 not in use