dynasonics Badger Meter IS-6000 Doppler User Manual

 Calibration
Before you start to enter values, please check and define the displayed units in the main menu  Settings under
 Displayed Units. Enter values for Q meas (IS-6000 Doppler) and Q ref (reference device) in table of values:
Setting Description
Date > Enter date.
W > Enter water level.
Q meas > Enter measured Q value.
Q ref > Enter reference Q value
(from reference device).
 active /
 delete
> Tick checkbox to activate or delete value pair for calibration curve.
 Click Apply to save settings. Values are displayed in the list above.
 Click Add new measurement to enter additional values.
Definition and graph of regression for calibration curve within discharge range
(Q min / Q max):
Active  /  >  Tick checkbox to enable curve fitting.
Fit
 linear
polynomial 2nd
polynomial 3rd
polynomial 4th
> Select curve fitting options from drop-down menu.
Q max > Enter maximum for discharge value.
Q min > Enter minimum for discharge value.
R-Coefficient > Shows calculated regression coefficient.
Programming
Page 56 March 2021HYB-UM-03155-EN-03

dynasonics Badger Meter IS-6000 Doppler Specifications

General

Brand	dynasonics
Model	Badger Meter IS-6000 Doppler
Category	Measuring Instruments
Language	English