7.13. Abbreviations
OTE: N Display of parameters may vary according to the connected flow meter type.
(Parameter list under Diagnosis Data)
Abbreviation Explanation
A cross section area of flow
CellSignal_01 …
CellSignal_18
signal strength of single measuring cells
(for example CellSignal_01: signal strength in cell 01)
DVol daily volume
DVolAbs daily volume absolute
DVolNeg daily volume negative (negative flow direction)
DVolPos daily volume positive (positive flow direction)
H water level, total
HAir water level (external ultrasonic down-looking level sensor
HUS water level (area velocity sensor)
HWater water level (external hydrostatic level sensor)
OpHCount operation time in hours
Q discharge, flow
Status status message of measuring system (only for internal use)
Salinity salinity
Signal signal strength
TAir air temperature measured with additional external temperature sensor
TS Timestamp
TWater water temperature measured with additional external temperature sensor
TotalVolume total volume
Volume volume – since last volume reset
VolumeAbs volume absolute – since last volume reset
VolumeNeg volume negative (negative flow direction) – since last volume reset
VolumePos volume positive (positive flow direction) – since last volume reset
v velocity
vCell_01 … vCell_19 mean velocity in single cell
(for example vCell_01: velocity in cell 01)
vm mean velocity
Parameter list for transmitter LCD display
TimeStamp current time
Wlan active connection via WLAN
Ether active connection via Ethernet / LAN
SysName display of system name
Location display of name of measuring site
CPUF processor frequency
Text> display text
Programming
Page 100 March 2021HYB-UM-03155-EN-03
To Next Page
Loading...
Need help?
General
