Dynatest FWD - 4.3 Completing the Setup

2017.06.19 FwdMan2.8.17.docx 4-29
4.3 Completing the Setup
This section shall address setup of the FWD/HWD hardware components. These components
include the following (note that some of the components are optional and may not be present
on your FWD/HWD):
 Loading Unit
 System Controller
 Load cell
 Deflectors
 Air Temperature Sensor
 Surface Temperature Sensor
 Distance Measurement (DMI)
 Global Positioning System (GPS)
In order to complete the setup, the user must be “Administrator” (see Section 4.1.4).
IMPORTANT!
Hardware parameters (like all other parameters) are stored in a database
file in order to better manage multiple RSP setups.
Before making changes to Hardware parameters make sure that you have
activated the correct equipment S/N in the introductory screen (8002-XXX).
Any changes you make to the hardware setup – be it calibration or
otherwise - will be stored in the equipment information file you selected in
the introductory screen.