2017.06.19 FwdMan2.8.17.docx 7-53
7.2 Connecting the Computer
7.2.1 Interface connections
To interface the Compact15 System Controller to the Computer, connect the Ethernet RJ45
socket on the Compact15 System Controller to the “CP15” RJ45 socket on the Remote
Control Box using a standard CAT5 patch cable.
If you use a Router (or ‘Switch’):
Connect a Cross-Over Ethernet cable from the “PC” RJ45 socket on the Remote Control
Box to one of the Network sockets on the Router.
Connect a standard Ethernet cable from the computer to another socket on the Router (the
Router / Computer connection could also be established wirelessly).
If you use Direct connection (no Router):
Connect a standard CAT5 patch cable from the “PC” RJ45 socket on the Remote Control
Box to the Network socket on the Computer.
7.2.2 Power Connections
Normally, the computer will be powered by connecting the line voltage power cord of the
Computer power adapter to a provided static inverter (which inverts 12VDC from the
Electronics Buffer Battery to AC line voltage).
Alternatively, a 12VDC powered computer power adapter may be used, connected to e.g. a
cigarette lighter adapter.
To Next Page
Loading...