EDR-3000 IM02602003E
Name Description
DI-8P X1.DI 2 Signal: Digital Input
DI-8P X1.DI 3 Signal: Digital Input
DI-8P X1.DI 4 Signal: Digital Input
DI-8P X1.DI 5 Signal: Digital Input
DI-8P X1.DI 6 Signal: Digital Input
DI-8P X1.DI 7 Signal: Digital Input
DI-8P X1.DI 8 Signal: Digital Input
RO-3ZI X2.ZI OUT Signal: Zone Interlocking OUT
RO-3ZI X2.RO 1 Signal: Relay Output
RO-3ZI X2.RO 2 Signal: Relay Output
RO-3ZI X2.RO 3 Signal: Relay Output
RO-3ZI X2.DISARMED! Signal: CAUTION! RELAYS DISARMED in order to safely perform maintenance while eliminating the risk of
taking an entire process off-line. (Note: Zone Interlocking and Supervision Contact cannot be disarmed). YOU
MUST ENSURE that the relays are ARMED AGAIN after maintenance
RO-3ZI X2.Outs forced Signal: The State of at least one Relay Output has been set by force. That means that the state of at least one
Relay is forced and hence does not show the state of the assigned signals.
RO-3 X2.RO 1 Signal: Relay Output
RO-3 X2.RO 2 Signal: Relay Output
RO-3 X2.RO 3 Signal: Relay Output
RO-3 X2.DISARMED! Signal: CAUTION! RELAYS DISARMED in order to safely perform maintenance while eliminating the risk of
taking an entire process off-line. (Note: Zone Interlocking and Supervision Contact cannot be disarmed). YOU
MUST ENSURE that the relays are ARMED AGAIN after maintenance
RO-3 X2.Outs forced Signal: The State of at least one Relay Output has been set by force. That means that the state of at least one
Relay is forced and hence does not show the state of the assigned signals.
RO-5 X2.RO 1 Signal: Relay Output
RO-5 X2.RO 2 Signal: Relay Output
RO-5 X2.RO 3 Signal: Relay Output
RO-5 X2.RO 4 Signal: Relay Output
RO-5 X2.RO 5 Signal: Relay Output
RO-5 X2.DISARMED! Signal: CAUTION! RELAYS DISARMED in order to safely perform maintenance while eliminating the risk of
taking an entire process off-line. (Note: Zone Interlocking and Supervision Contact cannot be disarmed). YOU
MUST ENSURE that the relays are ARMED AGAIN after maintenance
RO-5 X2.Outs forced Signal: The State of at least one Relay Output has been set by force. That means that the state of at least one
Relay is forced and hence does not show the state of the assigned signals.
Event rec.Res all rec Signal: All records deleted
Waveform rec.Recording Signal: Recording
Waveform rec.Memory full Signal: Memory Full
Waveform rec.Clear fail Signal: Clear Failure in Memory
Waveform rec.Res all rec Signal: All records deleted
Waveform rec.Res record Signal: Delete Record
www.eaton.com 721
To Next Page
Loading...
