1.2 Equipment marking – identification plate
Information on equipment marking and information on the rating plate can be
found in chapter
Ä
Chapter 11 ‘Technical data’ on page 95 .
The correct specification of the name and type is important for all queries.
This is the only way of ensuring fast and accurate processing of your enquiry.
1.3 Warranty
Our products are built, tested and CE certified in accordance with current
standards/guidelines. They left the factory in a safe, faultless condition.
T
o keep the equipment in this condition and to ensure risk-free operation,
the user must observe the instructions/warnings, maintenance regulations,
etc. contained in these operating instructions and, if applicable, affixed to the
product. The warranty conditions of the manufacturer apply.
The manufacturer provides a warranty for operational safety, reliability and performance
only under the following conditions:
n Assembly, connection, set-up, maintenance and repair must be carried out by qualified
and authorised specialists.
n DryExx®-Advanced-ETH is used in accordance with the information provided in these
operating instructions.
n Only OE spare parts are to be used for repairs.
n Only approved Ecolab products are used.
1.4 Transportation
NOTICE!
Material damage due to improper transportation.
Transport units can fall or tip over if improperly transported. This may result in
material damage. During unloading, delivery or even during general shipping,
proceed safely and pay attention to the symbols and the information on the
packaging.
Transport inspection
Check delivery for completeness and transport damage and complain about any defect.
Claims for damages can only be asserted within the complaint periods.
Procedure in case of externally visible transport damage
Do not accept the delivery or accept it only with reservations. Note the extent of the
damage on the transport documents, the carrier's delivery note and make a complaint
immediately
.
General
8Ver. 08-04.2024
To Next Page
Loading...
