2 Safety
DANGER!
If you believe that the unit can no longer be operated safely
, you must
decommission it immediately and secure it so that it cannot be used
inadvertently.
This applies:
–
if the unit shows visible signs of damage,
– if the unit no longer appears to be operational,
– after prolonged periods of storage under unfavourable conditions.
The following instructions must always be observed:
–
Prior to carrying out any work on electric parts, switch off the power supply
and secure the system against being switched back on again.
– Safety regulations and prescribed protective clothing when handling
chemicals should be followed.
– Attention must be paid to the information included on the product data
sheet of the metering medium used.
– The unit must only be operated with the supply and control voltage
specified in the Technical Data section.
CAUTION!
Operation is permitted only by trained personnel
– control unit must be operated only by trained personnel using PPE.
–
Suitable measures must be taken to prevent access by unauthorised
personnel to the control unit.
CAUTION!
Do not operate the control unit if you feel drowsy
, are physically unwell, or
under the influence of drugs / alcohol / medication, etc.
CAUTION!
Changes or modifications are not permitted without prior
, written permission
from Ecolab Engineering GmbH and result in the forfeiting of any and all
warranty entitlements. Original spare parts and accessories approved by the
manufacturer heighten the degree of safety.
The use of other parts results in an exclusion of the warranty for any ensuing
consequences. Please consider that the CE conformity expires in case of
subsequent conversions
Safety
15 Ver. 08-04.2024
To Next Page
Loading...
