NOTICE!
Damage to property due to unsuitable tools
Use of unsuitable tools can cause damage to the control unit.
–
Use only the correct tools!
– Keep tools clean and in perfect condition; replace damaged tools!
NOTICE!
Property damage caused by foreign objects
Foreign objects and tools left behind in the Plant can result in significant
property damage.
–
At the end of each working day, check tools for completeness.
– Once all maintenance and repair work has been carried out, check for
foreign objects on the Plant and check that all tools are complete.
9.1 General faults
Behaviour in the event of a fault
1. Switch off the control unit immediately.
2. Secure the control unit against being switched back on.
3. Identify any faults that have occurred and rectify them immediately
.
4. After troubleshooting, put the control unit back into operation.
Find the cause of the problem in the list of causes below, and then continue with the
possible corrective actions. If the problem has not yet been resolved, it is advisable to
contact the service department Ecolab.
Fault description Cause Remedy
The control
unit will not switch
on:
Master switch in "0" position
Turn on the master switch.
Machine interrupts
ongoing operation
Overcurrent protection has been
triggered
Have an expert rectify the fault.
Industrial accident Improper operation / management
Immediately switch off the power supply.
Non-observance of prescribed safety
measures
Immediately switch off the power supply.
Not wearing personal protective
equipment (PSA)
Immediately switch off the power supply.
Other faults Faults in general
To rectify faults, contact the
Ä
manufacturer to arrange specialist personnel.
Malfunctions and troubleshooting
86Ver. 08-04.2024
To Next Page
Loading...
