Ecolab DryExx Advanced-ETH - Page 149

Return
area:
continual no. of this valve:
min
min
circuit:
default
actual
pulse time :
break time :
booster :
release :
Sec.
Sec.
off
off
Valve Times
Boost Times
ð
The ‘Parameters’ screen opens for the selected circuit.
4. Perform or check the following settings:
n Enter metering parameters for each lubrication circuit valve
Ä Chapter 8.7.1 ‘Set the valve times’ on page 81
n Set boost times if necessary
Ä Chapter 8.7.2 ‘Set the boost times’ on page 82
Commissioning / operation
45 Ver. 08-04.2024