Ecolab EcoAdd

7.9.12.2 [Select Batch] - [Initial preparation]
Fig. 65: Charge - [Initial preparation]
1.
[Main menu] :
Ä Chapter 7.6 ‘Main menu’ on page 66
2.
[Configuration menu] :
Ä Chapter 7.9 ‘Overview - Configuration’ on page 83
3. Use the scrollbar to scroll to the [Select Batch] menu option.
4. [Select Batch] - select.
ð
Screen switches to the selection level [Select Batch]
5. ‘Select initial preparation’.
ð
The ‘Initial preparation’ option field is marked.
6.
[ Press the Next button] .
ð
Screen change for setting: ‘Initial preparation’
/ ‘rate’.
7. Enter the quantity in litres (before the decimal point) using the scrollbar
.
8. ‘Select the quantity details in the decimal point position’.
9. Enter the quantity in litres (after the decimal point) using the scrollbar
.
10.
Press the Next button.
ð
Screen change for setting: ‘Initial preparation’
/ ‘capacity’.
11. Enter the capacity in percent (%) using the scrollbar
.
12.
Press the button.
ð
The setting is saved, and the screen switches back to the charge overview
.
13.
Press the button to return to the [Configuration menu].
14.
Pressing the button returns to the [Main menu].
15.
Pressing the button returns to the [Operating display].
Control / software
106Rev. 2-05.2018