9.8 Changeover ‘Operating Mode’
9.8.1
Operating Mode
Selecting the operating mode decides whether the pump is operated using internally set
values (Manual, Timer) or if an external signal determines the metering rate (pulse,
current).
Fig. 99: Overview: Operating mode
Factory setting: Manual
[Select Operating Mode] :
1.
[Call up Main menu] :
Ä
Chapter 7.6 ‘Main menu’ on page 66
2. [Select Operating Mode] .
ð
Screen switches to the selection level [Operating Mode].
3. Select the setting of [Operating Mode] :
n Manual
Ä
Chapter 9.8.1.1 ‘ [Operating Mode] [Manual]’ on page 149
n Pulse
Ä
Chapter 9.8.1.2 ‘ [Operating Mode] [Pulse]’ on page 149
n Power
Ä
Chapter 9.8.1.3 ‘[Operating mode] [Power]’ on page 153
n Timer
Ä
Chapter 9.8.1.4 ‘[Operating mode] [Timer]’ on page 156
– Weekly programme
Ä
Chapter 9.8.1.4.1 ‘[Operating mode] - [Timer] [Seven-day programme]’
on page 156
– Interval programme
Ä
Chapter 9.8.1.4.2 ‘[Operating mode] [Timer] [Select interval programme]’
on page 158
4.
Pressing the button saves the setting.
ð
The screen switches to the overview: [Main menu].
5.
Press the button.
ð
The screen switches back to the [operating display] .
Operation
148Rev. 2-05.2018
To Next Page
Loading...
Need help?
General
