7.9.10.3 Chemical selection from an integrated database
This function is only available when a database has been loaded onto the
pump. A loaded database is shown in the operating screen using the
corresponding symbols .
If you have installed a database, please contact the customer service
department at Ecolab.
If a database is installed, the metering chemical used can be configured. This
takes account of the service intervals as well.
The more aggressive the chemical is in combination with the pump materials
used (resistance), the earlier the service intervals will be due.
If you select a metering chemical from the integrated database, the pump sets
the service intervals automatically:
Ä
Chapter 7.9.11 ‘Service interval’ on page 102.
NOTICE!
If the metering chemical is not compatible with the pump material pairing, the
chemical name is displayed in red on the operating screen.
If no selection is made for the pump, in addition to ‘No details’ and ‘Manual’,
the use of a database can be applied, however
, please contact the customer
service department at Ecolab. This description displays the potential version
with database.
Fig. 60: Configuration: Metering chemical - database selection
Factory setting: No database installed
Control / software
100Rev. 2-05.2018
To Next Page
Loading...
Need help?
General
