Ecolab EcoAdd

7.8.4.2 [Operating mode] [T
imer] [Select interval programme]
Fig. 42: Operating mode: [Timer] [Select interval programme]
[Operating mode] - [Timer] [Select interval programme]- setting:
1.
[Main menu] :
Ä Chapter 7.6 ‘Main menu’ on page 66
2. [T
imer] [Select interval programme] - select.
3.
[Press the Next button] .
ð
Screen change to the selection of the timer interval (interval programme)
4. [Select interval programme] - select.
ð
Screen change for setting: ‘Interval programme’ - ‘Switch-on duration’
5. Use the scrollbar to set the time/hours.
6. select time / minutes.
7. Use the scrollbar to set the time/minutes.
8.
Press the Next button.
ð
Screen change for setting: ‘Switch-off duration’
9. Use the scrollbar to set the minutes.
10. Select seconds.
11. Use the scrollbar to set the seconds.
12.
Press the Next button.
ð
Screen change for setting: ‘start state’
13. If required, select ‘Start condition OFF’
14.
Press the Next button.
ð
Screen change for setting: ‘Capacity’
15. Set the litres with the scrollbar
.
16. Select the ml range.
17. Set ml using the scrollbar.
18.
Press the button.
ð
Setting are saved, and the pump switches back to the ‘operating mode’ screen.
19.
Y
ou can return to the ‘main menu’ by pressing the
button.
20.
Pressing the button returns to the [Operating display].
Control / software
82Rev. 2-05.2018