2.8 Obligations of the operator
In the EEA (European Economic Area), national implementation of the
Directive (89/391/EEC) and corresponding individual directives, in particular
the Directive (2009/104/EC) concerning the minimum safety and health
requirements for the use of work equipment by workers at work, as amended,
are to be observed and adhered to.
The operator must adhere to the local legal provisions for:
n personnel safety (employers' insurance association and accident prevention
regulations, workplace directives), e.g. operating instructions, including those in
accordance with Section 20 Hazardous Substances Ordinance (GefStof
fV), personal
protective equipment (PPE), health screening;
n safety of work materials and tools (protective equipment, work instructions, procedural
risks and maintenance);
n product procurement (safety data sheets, list of hazardous substances);
n disposal of products (Waste Act);
n disposal of materials (decommissioning, Waste Act);
n cleaning (detergents and disposal);
n as well as complying with current environment protection regulations.
The owner is also required:
n to provide personal protective equipment (PPE).
n to incorporate the measures into operating instructions and to instruct personnel
accordingly;
n for operating sites (from 1m above ground): to provide safe access;
n to provide suitable workplace lighting in accordance with ASR 7/3.
n to ensure that local regulations are complied with during installation and
commissioning, if these procedures are conducted by the owner
.
2.9 Further safety settings
CAUTION!
When the pump is first started, NO ACCESS CODE is activated!
During the initial configuration of the pump, we strongly recommend enabling
the [access code] and only disclosing the set passwords to authorised
personnel:
Ä
Chapter 7.9.4 ‘Access code’ on page 88
To exclude the possibility of the pump being used improperly and / or of the
system parameters being adjusted inadvertently, the pump software must be
protected by the integrated multi-stage [access code] .
Setting the access code also protects the pump against unauthorised
access via a smartphone connected via Bluetooth. An unprotected pump
can be accessed via the EcoAPP without restriction!
If an access code has been defined on the pump, the pump will only be visible
in the EcoAPP once the correct access code for the pump has been entered in
the EcoAPP settings.
Safety
23 Rev. 2-05.2018
To Next Page
Loading...
Need help?
General
