Ecolab EcoAdd

7.9.12.3 [Select Batch] - [Initial concentration]
Fig. 66: Charge - [Initial preparation]
1.
[Main menu] :
Ä Chapter 7.6 ‘Main menu’ on page 66
2.
[Configuration menu] :
Ä Chapter 7.9 ‘Overview - Configuration’ on page 83
3. Use the scrollbar to scroll to the [Select Batch] menu option.
4. [Select Batch] - select.
ð
Screen switches to the selection level [Select Batch]
5. ‘Preparation concentration’.
ð
The ‘preparation concentration’ option field is marked.
6.
[ Press the Next button] .
ð
Screen change for setting: ‘Preparation concentration’ / ‘water quantity’.
7. Enter the quantity in litres using the scrollbar
.
8.
[ Press the Next button] .
ð
Screen change for setting: ‘Preparation concentration’ / ‘concentration’.
9. Enter the concentration in percent (%) using the scrollbar
.
10. ‘Select the concentration in the decimal point position’.
11. Enter the concentration in percent (%) (after the decimal point) using the scrollbar
.
12.
[ Press the Next button] .
ð
Screen change for setting: ‘Preparation concentration’ / ‘metering time’.
13. Enter the metering time in minutes using the scrollbar
.
14.
Press the button.
ð
The setting is saved, and the screen switches back to the charge overview
.
15.
Press the button to return to the [Configuration menu].
16.
Pressing the button returns to the [Main menu].
17.
Pressing the button returns to the [Operating display].
Control / software
107 Rev. 2-05.2018